Unknown carrier bearing
3d printed carbon fiber
New design for maximum link clearance
Includes pair of 5x10x4 bearings
Left or Right motor selection
Use (axi31410) shaft for best fit (Not included)
3d printed carbon fiber
New design for maximum link clearance
Includes pair of 5x10x4 bearings
Left or Right motor selection
Use (axi31410) shaft for best fit (Not included)
3d printed carbon fiber
New design for maximum link clearance
Includes pair of 5x10x4 bearings
Left or Right motor selection
Use (axi31410) shaft for best fit (Not included)
Select the carrier that’s optimal for your transmission output. I.e. Left trans output, use left carrier bearing. Right trans output, use Right carrier bearing.
Important! Make sure the mounting hardware dose not protrude more than 10mm into the mount to avoid potential damage. Uses M3 hardware.
Important! This carrier is optimized for the Dlux portal or NOD transmissions. Fabrication may be required if using other transmission configurations